← News & insights

Key Energy-Efficiency Metrics for Architectural Glass

640.jpg

Fenestration accounts for 40–50% of energy loss across the building envelope. While larger glazing areas improve daylighting and views, they increase thermal load. Low-E insulating glass units (IGUs) with a double-silver Low-E coating (surface emissivity e=0.04) and inert-gas fill can achieve a U-value of 1.1–1.3 W/m²K, a level the industry rates as thermally equivalent to a 370 mm brick wall.

Daylighting performance is quantified by visible light transmittance (VLT). JGJ 151-2008 defines VLT as the ratio of indoor visible-light flux to incident visible-light flux, weighted by the standard photopic luminous-efficiency function. Higher VLT yields better natural illumination. Thermal insulation is expressed by the U-value; under the same standard, this is the rate of heat transfer per unit area per 1 K temperature difference, expressed in W/m²K. Lower U-values indicate better thermal resistance.

Solar control is measured by total solar infrared transmittance (gIR). HB 002-2014 defines gIR as the solar transmittance in the 780 nm–2500 nm range; lower values indicate stronger rejection of solar radiant heat. The overall solar heat gain coefficient (SHGC), termed “total solar energy transmittance” (g-value) in JGJ 151-2008, captures the full fraction of incident solar radiation that enters the interior as heat, including directly transmitted radiation and secondary heat transfer from absorbed radiation. A higher g-value/SHGC denotes greater solar heat gain.

Specifiers should balance VLT, U-value and SHGC against facade orientation and climate. Selecting the right combination—for example, a low U-value with a tuned SHGC—reduces HVAC loads without sacrificing usable daylight.